This Low Profile Boat Trailer V Guide Kit Consists of All Aluminum and Stainless Steel Parts as well as Stoltz Polyurethane Rollers and Skids Pads, making it the longest lasting V Guide on the Market! The U Bolts, U Bolt Hardware (flat washers, lock washers and hex nuts), Roller Shaft, and Cotter Pins are all Stainless Steel. The Bracket Mounts and Pad Mounts are Aluminum. This Kit is Designed to Fit Around 3 x 3 inch (V-Bend cross members only) with the included Stainless Steel U Bolts and Hardware. With this setup you could mount (2) V Guides to each side of your 3x3 V Bend Crossmembers if you used through bolts instead of the included U Bolts. These V Guides are typically mounted along the center line of your boat, the height is not adjustable in this version of the v guide, instead it is a "short" or "low profile" version so you can use the v guide as low as it will go without having to worry about the bottom of the bracket scraping on the boat ramp during launching/loading.
This kit is intended for V Bend 3 x 3 crossmembers Only, it is not intended for use on straight cross members.
The 12 inch Stoltz Poly Keel Roller is designed to assist you in loading the boat onto the trailer, to help give you that extra push and line up your boat. The Stoltz material is made of the Highest Quality Polyurethane that has been tested and proven to outlast "poor quality" poly rollers, it will not mark or mar your boat and it will not dry rot from sun exposure.
The Parts in this kit will not rust from saltwater corrosion, but this kit would ideally be mounted on aluminum crossmembers to Prevent Galvanic Corrosion from mixing Aluminum + Galvanized Steel in Saltwater.
Sturdy Built Tough
This item was made to be the best of the best for what it does on a trailer. Sturdy Built Tested and Approved to be Sturdy enough for even the largest boats, and Built to stand the test of time - even in Saltwater.