This 3,500lb Galvanized Boat Trailer Axle has a V-Bend in the center for clearance with your Boat's Hull and is designed to fit a
6-foot wide I-Beam Trailer. The Hub Face (Track Measurement) on this Torsion Axle Measures 86 inches. It comes equipped with Galvanized 5 Lug Idler Hubs and features a greasable spindle, along with the standard 1.98 inch Accu-Lube Style Dust Cap so you can easily add grease to the Bearings. It also has a standard 4 Hole Brake Flange for installing Trailer Disc Brakes, and measures 80 inches from Brake Flange to Brake Flange, and 74.5 inches to the Outside of the Torsion Mounting Bracket. The Starting Angle of this Torsion Style Boat Trailer Axle is 30 Degrees Down. Torsion Bar Axles are perfect for Salt Water Boat Trailers because they last longer than Leaf Springs which quickly turn to rust.
The hubs are included pre-installed on this Torsion Axle. The Trailer Hubs use a standard 3.5k Capacity Bearing Combination, with a 1 3/8-inch inner bearing (Bearing Number L68149) and a 1 1/16-inch outer bearing (Bearing Number L44649). The Seal Size for this galvanized hub is 1.72 (or 1.619). The Boat Trailer Hub uses the standard size lug nuts for trailer hubs and wheels, ½”x20, and the bolt pattern measures 4.5 inches. The axle/hub does not include brakes, but there is a standard 4 hole brake flange (2 7/8 inches center to center) on the Torsion Arm so you can mount disc brakes to it, or swap out the hub to drum if you prefer.
This pre-installed hub is already greased with a Lithium Based
Grease. Additional Lithium Grease may be
applied before use.
This Axle Requires A 72-inch (6-Foot) Wide, I-Beam Trailer (Measured
Outside to Outside) for proper fitment.
Completely Hot-Dipped Galvanized Construction, including the Torsion
30 Degree Down Starting Angle
Pre-Loaded 5 Lug Hubs
4-Hole Brake Flange for installing Brakes
Drain-Hole at the bottom of the V-Bend to Release Water Buildup
This Torsion Axle Does not include the mounting hardware, however,
we have (4) ½ x 1 ½ inch Stainless Steel Mounting Bolts as a selectable Add-On
to this product if needed.
New Mounting Holes May need to be drilled in order to install the
These Axles can be used on Continental Boat Trailers, Magic Tilt
Trailers, Loadmaster Trailers, Float On Trailers, and many others.