Tools You Will Need:
Power Drill with #2 Phillips Bit
Pencil or Pen
Sharp Utility Knife and Speed Square
As you can see the great thing about this product is that all the tools required are common tools. Installation Instructions are printable from our Website Below. These instructions are step by step and will guide you through the successfully completion of your Bunk Wrap project.
This Product has significant advantages including reduced friction, which will increase the eases of unloading and loading your boat. This will take stress off of your boat and yourself. In addition, the uniquely ridged material allows for easy rinsing to prevent debris from collecting on your bunks, which is an issue with carpet. Another unique quality of Caliber bunk wrap is its resistance to sun wear and dry cracking. The surface of this product is specifically designed and is guaranteed to perform in the harshest environments.
Bunk Slick products such as this are specifically intended to increase the ease of unloading and loading your boat. DISCLAIMER: BunkWrap is designed for raw aluminum boats, pontoons, and watercraft boat lifts. BunkWrap is not designed, or recommended, for gel-coat, fiberglass, or painted aluminum hulls.
This particular size kit includes (1) 16 ft Piece of Bunk Wrap to be cut for your two bunk boards, (4) End Caps, and Packaged hardware screws for installation.
This Kit Includes:
(1) 16ft Piece of Bunk Wrap for 2 x 6
(4) Bunk Wrap Ends for 2 x 6
(33) Stainless Steel #10 Truss Head Screws
(16) Stainless Steel Screw #8 Flat Head Screws
Follow the instructions available in the link to ensure proper fit. Instructions are based off 16ft Kit for 2 x 4, but are applicable for this size kit as well.