This 12 inch Vertical Galvanized Bunk Bracket allows you to vertically mount a 2 in x 4 in or 2 x 6 bunk board. These vertical bunk brackets are very common on flat bottom john boats and skiff boats. They would also be adequate for V-Hull Boats and Jet Ski trailers. Typically a single axle trailer would have 4 of these mounted to hold up the boat. The 1/2 inch adjustable slotted holes allow for you to fix the height of your bunks to get the right ride height for your boat. If you are needing a different height we also have available the 10 inch Vertical Bunk Bracket Galvanized and 8 inch Vertical Bunk Bracket Galvanized Ideally, you would use either Trailer Bolts or Boat Trailer U-Bolts to mount these bunk brackets around your boat trailers cross-members. The cross-members are the the pieces of either galvanized channel, tubing, or aluminum tubing that connect one side of the trailer frame to the other, typically in front, and behind the trailers axle or axles. In some cases with a tandem axle trailer, there may be 3 cross-members. When mounting this 12 inch Vertical Galvanized Bunk Bracket, mount the flat side to the face of the cross-member, and the open side will face away from the cross-member.
Important things to consider when replacing Vertical Bunk Brackets.
1. Desired Bunk Board Height- Do you want the same size or would you prefer a shorter, or taller height for your boat. If you are going shorter keep in mind the changing ride height of the boat puts it closer to the trailer fenders and also the motor closer to the ground.
2. Keep Track of Hardware needed to replace the bunks. These bunk brackets will mount with either 1/2 inch bolts or U-Bolts. Determine which is needed, and the appropriate measurement. Most commonly, U-Bolts fasten around the trailers cross-member, and through the slotted holes. Determine the dimension needed to go around the cross-member by measuring the height and width. Keep in mind to add extra length for the nuts and washers.
You may also need a through bolt for the desired bunk board you will be installing in the bunk bracket. The correct size bolt is a 3/8 x 3 inch bolt available in Stainless Steel and Zinc Plated.
Vertical Bunk Bracket Project Check List:
| || Boat Trailer U-Bolts are used to mount your new Bunk Bracket to your trailers Cross Member, measure the height and width of your frame and select from Galvanized or Stainless Steel Trailer U Bolts in 1/2" Diameter.|
| || Trailer Bolts are used to secure your boat trailers Bunk Boards to your Vertical Bunk Bracket, available in stainless steel and galvanized. The 3/8" x 3" is the recommended Length. |
| || || Marine Bunk Board Carpet is used to wrap your boat trailers bunk boards to protect your boat hull from damage, available in several different widths for 2" x 4" and 2"x 6" boards. |
| || || Boat Trailer Bunk Boards are used to support your boats weight and assist with loading and unloading and are mounted directly to the Bunk Bracket with Lag Screws. |